DESCRIPTION:A polyester-based, hydroxyl-functional, aliphatic, water-borne polyurethane dispersion.
SUGGESTED USES:HD-6000 was developed for use with water-dispersible, isocyanate crosslinkers such as Bayer's Bayhydur 302 or Perstorpís Easaqua X D 401. The product, when crosslinked provides tough, chemical resistant, glossy coatings which may be applied to a variety of substrates including concrete, metals, plastics and wood materials. This product exhibits superior chemical resistance, while maintaining excellent flexibility and gloss retention characteristics.
- Superior chemical resistance
- Excellent exterior weathering durability
- Excellent humidity resistance
- Contains n-methyl pyrrolidone co-solvent
APPLICATION:HD-6000 crosslinked with water-dispersible isocyanates may be spray applied using single-component equipment. The workable potlife is approximately 3 hours at the suggested crosslinker ratio of 2.0 to 1.0 NCO / OH.
CURING:HD-6000 crosslinked with a water dispersible isocyanate, will dry to a hard film in 30 minutes at ambient room temperature (65 - 70°F) and humidity (RH 50%). Ultimate cured properties will take about 3 -5 days to develop. If heat is available, the ultimate properties can be attained in shorter time. Typical oven drying temperatures and dwell times for aqueous coatings are sufficient to produce optimal film properties.
|SOLIDS: 35 (+/- 1%)
||(TESTED AT 20 INCHES/MINUTE)
|VISCOSITY: 50-500 cps
||ELONGATION: 230 %
|pH: 7.5 - 10.0
||TENSILE STRENGTH: 7000 PSI
|DENSITY: 8.8 lbs/gal
||100% MODULUS: 4850 PSI
|V.O.C. CONTENT: 126 gm/l
||200% MODULUS: 6800 PSI
|OH EQUIVALENT WT. 3,100 (as supplied)
||300% MODULUS: NA